Boat Access Hatch, 15-11/16" x 12-7/8" Locking Slam Latch System, Off-White - FO2347
MEASUREMENTS: Outside Dimensions: 15-11/16" x 12-7/8" (398mm x 327mm). Inside Dimensions: 11-1/8" x 8-1/4" (282mm x 209mm). Cutout: 12-1/2" x 9-11/16" (317 mm x 246 mm) x 1" (25 mm) (hatch hinges). Low Profile at 3/8" (10mm) above the mounting surface. Intrusion below deck: 3/4" (19mm).
MARINE-GRADE MATERIAL: Made of High-impact and non-corrosion Off-White Polypropylene. It's also UV-stabilized to minimize degradation from prolonged sunlight exposure. Designed to withstand rough weather conditions.
EASY INSTALLATION: Designed to install on an internal or external flat surface. Mounting Template Included. 10 Pre-drilled holes. Screw Caps provide a finished appearance and help keep out debris. Hinge offers a 120 degrees lid opening. Feature a locking Slam Latch Handle. Water-tight, Black rubber seal ensures weatherproofing.
SAFETY: The reinforced ribs make it capable of being stood or walked on for long periods. The low profile minimizes the chance of it being a tripping hazard. Great for use in a high-traffic area. Anti-slip/non-skid surface to avoid slippery situations.
APPLICATION: This hatch is ideal for additional storage (bait, daily catch, fuel line access, or any other compact equipment), ventilation, or Marine Inspection.
PRODUCT NUMBER: FO-2347
I am very impressed with the quality and fit. I am amazed at the quality for such a good price
It's a good hatch and probably the best replacement for the older ones of the same dimension, which do break after a couple decades. Perfect fit, built about identically. But if you plan to use it in the deck, do note that when a full-grown adult walks across it there is some flex.
Somewhat fast shipping but good quality
Fit like a glove. Nice upgrade to my grandson's boat.
Just ordered another one of these to replace another broken manufactor’s hatch on my boat. I have a VIP Bay Stealth and they no longer build boats so I put four of these on my boat two years ago and they have held up great! I weight 305 lbs and have stepped on them several times and they never have broken. I fish only salt water. I recommend not putting the little plastic screw covers they provide you. I think they may have caused my screws to rust out because of salt water being trapped under them. Also use silicone to seal them in good. These fit perfect but I did have to use a cutting wheel to notch out where the hinges are because they are a slight different design than the ones from the factory.